Activate the contouring toolbar – after Map3D BEM analysis.
The default configuration for this toolbar is as follows:
This toolbar is meant to provide quick access to commonly used stress parameters.
Plot > Stress > S1 Major Principal Stress
Plot > Stress > S3 Minor Principal Stress
Plot > Stress > Tmax Maximum Shear Stress
Plot > Stress activates the stress toolbar. This toolbar contains all stress components.
Plot > Surface Components activates the surface toolbar. This toolbar contains all surface components.
Plot > Strength Factors activates the strength factor toolbar. This toolbar contains all strength parameter components.
Plot > Stress > User User defined stress plot.
Plot > Range specifies the contour range (minimum, maximum, interval ...) of the currently plotted contour.
Plot > Grid Selection Activate the grid selection toolbar.
Plot > Surface Components > Options specifies contour plot options (trajectories, contour lines ...).
Tools > Contouring Toolbar Configure add or remove buttons from the contouring toolbar.
Notes:
Buttons can be moved around on the toolbar simply by holding down the left mouse button and dragging the button to the desired location.
The contouring toolbar can only be activated after the model building - CAD Stage